Probably similar processing power to some of the Windows netbooks or the new anemic Macbooks Apple sells now. Reaper has an older PPC compatible version, so you're covered on that end if you get a SATA SSD running. Well, looking it up to see which version of OSX started supporting it is still the starting point! It may be that you need a newer version of OSX than that computer can run to talk to that pci card. You'll want to look up that card and see if OSX 10.5 PPC includes class compliant drivers for it. This is to give you SATA ports, right? (Because the native drive connections are the old parallel connection.) You should definitely install at least that. I think 10.5 is the last PPC OSX that will run on that old G4. I even booted off of Panther install CD just in case if the drive is detected that point. Now I can see the card is detected (in System Profiler),īut somehow I see no trace of the SATA - Drive. I did the WiebeSATA3512Flash and wrote the firmware to the card (option A), first it failed nagging about the kext not being authentic, but I ran the *.command again and then it succeeded. It shipped configured with 128 MB of RAM, a 40 GB Ultra ATA/66 hard drive, a 12X CD-RW drive, and a 4X AGP NVIDIA GeForce 2 MX graphics card with 32 MB of SDRAM. I have a Silicon Image SIL 3512 SATA / RAID 2 Port PCI - CardĪnd a Toshiba 160GB SATA - Drive (it's a "Laptop" - model all I have in hand at this moment. The Apple Power Macintosh G4/733 (Quicksilver) features a 733 MHz PowerPC 7450 (G4) processor with the AltiVec 'Velocity Engine' vector processing unit and 256k 'on chip' level 2 cache. I'm trying to "upgrade" my PPC (OS X - 10.3.9 / Panther) - Setup.
0 Comments
Leave a Reply. |